30 or 40 Meter Half Wave Dipole Antenna with a W2FMI 1500 watt Balun 30-40HWDB

Description

Frequency Devices 30M to 40 M Half Wave Dipole Antenna Kit
with Balun
The Frequency Devices Half Wave Center Fed Dipole antenna can be used on any frequency from 10 to 7 MHz (30 Meters to 40 Meters).  It uses #14 7/22 stranded hard-drawn copper wires to meet the requirements of the National Electrical Code and have the best radiation efficiency.
Hard drawn wire is the best wire to use for antenna since it is much stronger than soft drawn and will stretch must less.
It can be installed as an inverted V or as a straight dipole. The antenna can handle 1500 watts PEP provided the SWR at the antenna is less than 2:1
The Frequency Devices antennas come with the ends un-terminated and ready for tuning at your site and under your conditions.  They come with complete simple instructions on how to adjust the length for proper tuning of the antenna.  You only need a SWR meter to adjust them – something that is built into most modern transmitters.
Our antennas are built using 18-8 stainless steel hardware, all internal nuts are self-locking, all screw holes are sealed with RTV sealant, and other holes are sealed with Coax-Seal™ to minimize water problems.  Our center isolators have weep holes in the bottom to allow any moisture that might accumulate to drain out.
The wire ends are twisted, soldered, and have shrink tubing installed.
These antennas are made in our factory in Illinois and shipped directly to you through the US Post Office and has a money back guarantee for two years.
The antenna usually will arrive two to three days after shipping.
This antenna comes with about 72 feet of wire.
Bill Franklin, K9EIF