General Pump #100774 Pressure Washer Chemical Injector 3/8" NPT 1.8mm 2-3 GPM

Description

General Pump #100774  Injector
Note:  Install the injector with the arrow pointed in the direction of the flow
Orifice
1.8 mm
GPM
2.0 to 3.0
Rated PSI
4500
Inlet
3/8" NPT-Male
Outlet
3/8" NPT-Male
Temperature
190° F max.
Hose Barb
1/4"
Up to a 20% injection draw rate • Available with both fixed and adjustable barbs
•
Made in the USA
• A cost effective solution to your chemical application need
This product is to be used with clean, fresh water. For different or corrosive liquids, contact GP Technical Service Department. With not clean liquids, appropriate filtration should be installed. Select the injector based on the nominal operating rating: system rated pressure, max flow and max temperature. Install valve with direction arrow pointing downstream. For proper operation a control device such as a dual lance wand, quick couple nozzles, or an adjustable nozzle holder must be used to lower the system pressure at the nozzle. Under no circumstances should the pressure of the system exceed the maximum rated pressure of any component.